- All
- Product Name
- Product Keyword
- Product Model
- Product Summary
- Product Description
- Multi Field Search
Views: 0 Author: Site Editor Publish Time: 2022-03-17 Origin: Site
1) Before operation, check whether the power is turned on, whether the air pressure is normal, clean up the dirt on the machine, and check whether the two end box covers are closed.
2) During operation, observe whether the machine operates normally. In case of any abnormality, press the emergency stop button immediately. Continue to work after the abnormality is eliminated.
3) Please supply power strictly according to the rated voltage indicated, otherwise it may cause damage to machine components or abnormal operation
4) It is forbidden to remove the machine parts or cables, etc. under the condition of power on, otherwise it may cause damage to the machine or personal injury.
5) Do not touch sliding parts or rotating parts during the operation of the machine, otherwise it may cause equipment failure or personal injury.
6) Avoid splashing any liquid on the electrical components, otherwise it may cause damage to the equipment components.
7) Do not step on the machine or place heavy objects on it, otherwise the machine may be damaged.
8) The grounding circuit of the equipment must be effective, otherwise electric shock may be caused.
9) When operating the machine, avoid personnel or objects in the unsafe range.
10) Pay special attention to that the hand cannot be placed below when the upper rubbing strip is pressed down.
Common Breakdown And Settlement
Item | Problem | Reason | Solution | Note |
1 | Twisting strip is uneven； | 1. Uneven strip sticking 2. Unevenness during rope rubbing | Empty twisting. | the beam drop down pressure <2kg |
2 | Threading not through the twisted fringes. | Threading above the twisted fringes. | Polish needle tip upper side. | |
Threading under the twisted fringes. | Polish needle tip underneath. | |||
3 | Twisting too tight | Twisting route too long | Connect No.4 inductive light close to No.5 inductive light | |
Pressure too big | Reduce pressure | |||
4 | The twisting at both ends is too tight | When second twisting, the upper twisting plate raise into lower position | Raise to higher position | |
5 | The tip of the needle is easily damaged | Pay special attention to the tip of the needle and the front guide of the threading seat | Center alignment | |
6 | It's hard to draw the needle | Sundries in the pinhole | Clear | The emergency stop button must be pressed before operation |
Loose drive belt | Tighten the drive belt |
